Printing machines often encounter various problems during use, such as frequent damage to parts and frequent electrical malfunctions. Some people say that the machine is too old. Of course, the old machine is an objective reason, but does the new machine not malfunction? Some printing factories have more new machine failures than old ones. Objectively speaking, the usage and failure rate of the machine include the following factors: manufacturing quality, installation and debugging, maintenance status, reasonable operation, and most importantly, maintenance quality. The quality of a machine objectively exists at the time of delivery, whether it is a new or old machine, installation and debugging are the first hurdle.
Generally, new machines are installed and debugged before leaving the factory, undergo quality inspection, and then undergo separate packaging and transportation. Not only is it a matter of level and reasonable installation, but there is also an issue of inspection and correction. This is even more true for old machines. As for maintenance and use, I won't say much. I just want to talk about the quality of maintenance:
Maintenance is not just about disassembly and assembly. It is not only about finding the cause of the malfunction, but also about identifying other issues that may arise as a result.
Printing machines have strict time coordination, assembly tolerances, and adjustment values. Busy disassembly and excessive adjustment are the main reasons for accelerated wear and repeated failures of the machine.
The procurement and processing quality of spare parts does not necessarily require the use of original parts for all components and electrical components. The cost of original parts is high, and the procurement cycle is long. Except for special or critical parts, most of the other parts and electrical components can be substituted, as long as the processing technology and component characteristics of the parts are understood.
In addition to natural damage to the machine, circuit faults are mainly hidden faults derived from careless disassembly and installation, or the failure to locate the machine and human factors that caused the circuit faults.
Troubleshooting of water tank liquid
Exploration of Common Problems in Printing Machine Sink Solution - Choosing the appropriate concentration of the solution is based on the conductivity value. When the conductivity is too high, the ink will not dry easily, and when it is too low, it is easy for the plate to become dirty or accumulate ink. So it is necessary to try to find the appropriate conductivity value. After finding the concentration value, multiply the total water tank volume by the percentage to determine the first addition amount. In addition, when the conductivity value changes by more than ± 50-100, it needs to be corrected before continuing to use. At the same time, it is also necessary to pay attention to the temperature in the water tank, as temperature can affect the measured value of conductivity.
The recommended ideal printing water conditions are:
(1) The water quality should be soft water;
(2) The conductivity value is 700-1300 (the conductivity value of water must be deducted);
(3) PH value 4.0~5.5;
(4) The temperature of the water tank is 5 ℃~15 ℃;
(5) Emulsification degree below 35%;
(6) Alcohol IPA ratio 5%~15%;
(7) The concentration ratio of the water tank solution is 1.5%~2.5%.
The following are the actual test results of our center in the printing laboratory:
Sink liquid: Magic 150
Conductivity Meter: Delta OHM Conductivity Meter Model: HD 8706
PH meter: HANNA PH meter Model: HI 8521
According to the above example, the total amount of water in the printing machine water tank of the central printing laboratory is 80000cc * 2%=1600cc, and the conductivity value is maintained at 1000 (1095-92.5) ± 100, with a pH value of about 5.0. In addition, we found that the pH value did not change significantly after the concentration of the water tank was 3%, so it is not easy to detect whether the amount is appropriate. In addition, some European water tank liquids have added more buffering agents, which are used to maintain a stable acidity of the water tank liquid and reduce corrosion of the layout. Therefore, there may be problems when measuring the concentration of the water tank liquid using the pH value.
Printing Machine Troubleshooting
Feb 06, 2024
Leave a message
Send Inquiry

