The drying device is an important part of the flexographic printing machine, so what are the characteristics of the drying device of the flexographic printing machine?
When the flexographic printing machine is started, the retracting and unwinding traction roller and motor vibrate violently with loud noise. At this time, pay attention to check the encoder of the driving motor. It can be eliminated by adjusting the P value parameter in the internal PID value of the traction inverter. Although the no-clean process is the development direction, military products should be used with caution.
The non-woven printing machine adopts a drying device, and the deformation of the printed sheet is small, which is conducive to ensuring the quality of the printed product. If there is a fully automatic computer plate registration device, the operation mode should be set on the automatic plate registration, the computer can automatically track, and if any deviation is found, it will automatically send out a correction signal to move the plate roller or substrate to re-align. Another one is to see if the contact surface between the stencil and the PCB is very large, or if the tin paddle is dry and cannot be scraped cleanly, these problems are not very complicated, and it is not difficult to deal with the actual situation.
The above is the introduction of the advantages of the drying device of the flexographic printing machine.